Controls
12
Red On L When the base unit is turned on, the STATUS indicator
lights in red for about 10 seconds.
Flashing L The base unit is registering a handset.
Flashing
rapidly
L The base unit is paging handsets. (KX-TGP500 only)
Amber On L The base unit’s IP address may conflict with the IP
addresses of other devices on your local network.
Contact your administrator for further information.
Flashing L The base unit is obtaining an IP address or is obtaining
configurations. Please wait.
L The base unit is registering with your phone system.
Please wait.
L If the STATUS indicator continues flashing, check the
following:
– Network settings may not be correct. Contact your
administrator.
– Many installation issues can be resolved by
resetting all the equipment. First, shut down your
modem, router, hub, base unit, and computer. Then
turn the devices back on one at a time in this order:
modem, router, hub, base unit, computer.
– If you cannot access Internet Web pages using your
computer, check to see if your phone system is
having connection issues in your area.
– For more troubleshooting help, contact your
administrator.
Flashing
rapidly
L Unplug the base unit’s AC adaptor to reset the unit,
then reconnect the AC adaptor. If the STATUS
indicator is still flashing rapidly, there may be a
problem with the base unit hardware. Contact your
phone system dealer.
Off — L The base unit power is off.
L The Ethernet cable is not connected properly. Connect
it.
L Your network devices (hub, router, etc.) are turned off.
Check the LEDs for the link status of the devices.
L The base unit power is booting up.
Status
Meaning
Colour Light
pattern
To Next Page
Loading...
