Useful Information
52
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programmable settings
Battery recharge
Problem Cause/solution
The display is in a
language I cannot
read.
L Change the display language (page 14).
While programming,
the display returns to
standby mode.
L A call matching an entry in the call barred list is being
received. Wait and try again later.
I cannot activate the
eco mode.
L You cannot set eco mode when you set the repeater
mode “On”. If required, set the repeater mode to
“Off” (page 32).
I cannot register a
handset to a base unit.
L The maximum number of base units (4) is already
registered to the handset. Cancel unused base unit
registrations from the handset (page 32).
L The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 32).
L You entered the wrong PIN. If you forget your PIN, see
“I cannot remember the PIN.” (page 52).
I cannot remember the
PIN.
L Change the PIN using the following method.
1 1 (centre of navigator key) i {#}{1}{3}{2}
2 {*}{7}{0}{0}{0}
3 Enter the new 4-digit base unit PIN. i M i
{ic}
Problem Cause/solution
The handset beeps
and/or ) flashes.
L Battery charge is low. Fully charge the batteries (page
9).
I fully charged the
batteries, but
– ) still flashes or
– the operating time
seems to be shorter.
L Clean the battery ends (S, T) and the charge
contacts with a dry cloth and charge again.
L It is time to replace the batteries (page 9).
The handset display is
blank.
L The handset is not turned on. Turn the power on (page
14).
TG8521E(e).book Page 52 Wednesday, March 17, 2010 3:39 PM
To Next Page