EasyManuals Logo

Panasonic Lumix DMC-F2 User Manual

Panasonic Lumix DMC-F2
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
Others
- 117 -
[READ ERROR PLEASE CHECK THE CARD]/
[WRITE ERROR PLEASE CHECK THE CARD]
It has failed to read or write data.
"
Turn the camera off and remove the card. Insert the card again, turn the power on,
and try to read or write the data again.
The card ma
y be broken.
"
Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
When you set the picture quality to [WVGA] or [VGA], we recommend using a high-
speed card with “10 MB/s” or greater displayed on the package.
If the operation stops even if you use the card with memory size of 10
MB/s or greater,
this means the data-writing speed has lowered. We recommend backing up the data and
formatting the card. (P27)
Depending on the type of SD Memory Card or SDHC Memory Card, motion picture
recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
A f
older cannot be created because there are no remaining folder numbers that can be
used. (P98)
"
Format the card after saving necessary data on a PC etc. (P27)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
The AV cable is connected to the camera.
"
Press [MENU/SET] if you want to delete this message at once.
"
Select [TV ASPECT] in the [SETUP] menu to change the TV aspect. (P27)
This message also appears when the USB connection cable is connected to the camera
only. In this case, connect the other end of the USB connection cable to a PC or a
printer. (P96, 99)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
The pr
inter cannot print.
"
Chec
k the printer.
[NO BATTERY POWER REMAINS]
The remaining batter
y power is low.
"
Charge the batter
y.
[THIS BATTERY CANNOT BE USED]
The batter
y cannot be recognized by the camera.
"
Use a gen
uine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
The batter
y cannot be recognized as its terminal is dirty.
"
Remo
ve any dirt etc. from the terminal.

Table of Contents

Other manuals for Panasonic Lumix DMC-F2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Panasonic Lumix DMC-F2 and is the answer not in the manual?

Panasonic Lumix DMC-F2 Specifications

General IconGeneral
BrandPanasonic
ModelLumix DMC-F2
CategoryDigital Camera
LanguageEnglish

Related product manuals