Connecting to other equipment
- 98 -
Disconnecting the USB connection cable safely
• Proceed with the hardware removal using “Safely Remove Hardware” on the task tray
of the PC. If the icon is not displayed, check that [ACCESS] is not displayed on the LCD
monitor of the digital camera before removing the hardware.
Note
• W
e recommend placing a soft cloth under this unit to prevent scratching.
• Turn the camera off before connecting or disconnecting the AC adaptor (optional).
• Before inserting or removing a card, turn the camera off and disconnect the USB
connection cable. Otherwise, data may be destroyed.
• With the Mac OS X v10.2 or an earlier operating system, set the Write-Protect switch of
the SDHC memory card to the [LOCK] position when importing pictures from an SDHC
memory card.
Viewing the contents of the built-in memory or card using the PC (folder
composition)
1
F
older number
2
File n
umber
3
JPG :
Pictures
MOV : Motion pictures
MISC: PRINT SET
Favorite
Built-in
memory
Card
•
•
A new folder is created when pictures are taken in the following situations.
• When a card containing a folder with the same folder number has been inserted (Such
as when pictures were taken using another make of camera)
• When there is a picture with le number 999 inside the folder
Connection in the PTP mode (Windows
®
XP, Windows Vista
®
, Windows
®
7 and Mac
OS X only)
Select [PictBridge (PTP)] when connecting USB cable.
Data can now be read only from the card into the PC.
• When there are 1000 or more pictures on a card, the pictures may not be imported in
the PTP mode.
Using a PC with an SD Memory Card slot or a card reader
Attach the SD card according to the operating instructions of computer or card reader and
perform steps
3
-
5
on page 97.
• You cannot use SDHC cards if the computer or card reader does not support SDHC
cards.
To Next Page
Loading...
Need help?
General
