Advanced-Viewing
- 94 -
c
[PROTECT]
You can set protection for the pictures you do not want to delete to prevent them from
accidental erasure.
1
Select [PROTECT] on the [PLAYBACK] menu. (P21)
2
Press
e
/
r
to select [SINGLE] or [MULTI] and then
press [MENU/SET].
[SINGLE] [MULTI]
Press
w
/
q
to
select the picture.
Press
e
/
r
/
w
/
q
to
select the pictures.
3
Select the picture, and then
press [MENU/SET] to set.
When [MULTI] has been selected
• Repeat these steps for each picture.
• The settings are canceled when
[MENU/SET] is pressed again.
4
Press [
4
] to return to the menu screen.
• Press [MENU/SET] to close the menu.
Canceling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step
2
and then press [MENU/SET].
2 Press
e
to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
• If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
Note
• The protect setting may not be effective in other equipment.
• Even if you protect pictures in the built-in memory or a card, they will be deleted if the
built-in memory or the card is formatted.
•
Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card,
they cannot be deleted when the card’s Write-Protect switch is set to [LOCK].
To Next Page
Loading...
Need help?
General
