Preparation
- 15 -
Using an AC adaptor (optional) and a DC coupler (optional) instead of the battery
Ensure that the AC adaptor (optional) and DC
coupler (optional) are purchased as a set. Do not
use if sold separately.
1
Open the card/battery door.
2
Insert the DC coupler, being careful of the
direction.
3
Close the card/battery door.
• Ensure that the card/battery door is closed.
4
Open the DC coupler cover
A
.
• If it is difcult to open the cover, open the card/
battery door, and then press the coupler cover
from inside to open.
5
Plug the AC adaptor into an electrical outlet.
6
Connect the AC adaptor
B
to the [DC IN] socket
C
of the DC coupler.
D
Align the marks, and insert.
• Ensure that only the AC adaptor and DC coupler for
this camera are used. Using any other equipment
may cause damage.
Note
• Always use a genuine Panasonic AC adaptor (optional).
•
Some tripods cannot be attached when the DC coupler is connected.
• Make sure to unplug the AC adaptor when you open the card/battery door.
• If the AC adaptor and DC coupler are not necessary, then remove them from the digital
camera. Also, please keep the DC coupler cover closed.
• Also read the operating instructions for the AC adaptor and DC coupler.
• If the power supply from the outlet is cut off while recording motion pictures using the
DC coupler, the pictures being shot will not be recorded. Securing stable power supply
or using the battery is recommended.
To Next Page
Loading...
Need help?
General
