Others
- 119 -
Shooting
The picture cannot be recorded.
• Is the mode correctly set? (P20)
• Is there any memory capacity left on the built-in memory or the card?
¡
Before recording, delete some pictures. (P
40)
The recorded pictures are pale.
• The picture can become whitish if there is dirt e.g. ngerprints on the lens.
¡
If the lens is dirty, turn on the camera, eject the lens barrel (P
9) and gently wipe the
lens surface with a soft dry cloth.
The area around where the pictures were taken becomes dark.
• Was this picture taken with the ash at the close range when the zoom is near [W] (1×)?
¡
Zoom in a little, and then take the pictures. (P
35)
The recorded picture is too bright or dark.
¡
Check that the exposure is correctly compensated. (P51)
2 or 3 pictures are taken at one time.
¡
Set other than [HI-SPEED BURST] (P59), [FLASH BURST] (P59) in Scene Mode or
set [BURST] (P
76) to [OFF].
The subject is not focused properly.
• The focus range varies depending on the Recording Mode.
¡
Set the proper Recording Mode for the distance to the subject.
• Is the subject out of the focus range? (P
29, 32 and 49)
• Have you taken a picture with jitter? (P
34)
The recorded picture is blurred.
¡
The shutter speed becomes slower when pictures are taken in dark places so hold
the camera rmly with both hands to take the pictures. (P
28)
¡
When taking pictures at a slow shutter speed, use a tripod or the self-timer. (P
50)
¡
When you do not use the Digital Zoom, set it to [OFF] and the sensitivity to [i.AUTO].
(P
71)
To Next Page
Loading...
Need help?
General
