VQT1V73
16
Preparation
∫ Using an AC adaptor (optional) and a DC coupler (optional) instead of the battery
Ensure that the AC adaptor (DMW-AC5PP;
optional) and DC coupler (DMW-DCC4; optional)
are purchased as a set. Do not use if sold
separately.
1 Open the card/battery door.
2 Insert the DC coupler, being careful of the
direction.
3 Close the card/battery door.
• Ensure that the card/battery door is closed.
4 Open the DC coupler cover A.
5 Plug the AC adaptor into an electrical outlet.
6 Connect the AC adaptor B to the [DC IN] socket
C of the DC coupler.
D Align the marks, and insert.
• Ensure that only the AC adaptor and DC coupler for this
camera are used. Using any other equipment may
cause damage.
Note
• Always use a genuine Panasonic AC adaptor (DMW-AC5PP; optional).
• Some tripods cannot be attached when the DC coupler is connected.
• Make sure to unplug the AC adaptor when you open the card/battery door.
• If the AC adaptor and DC coupler are not necessary, then remove them from the digital
camera. Also, please keep the DC coupler cover closed.
• Also read the operating instructions for the AC adaptor and DC coupler.
• For information about optional accessories, refer to the “Digital Camera Accessory System”.
(P110)
About the Built-in Memory/the Card
The following operations can be performed using this unit.
• When a card has not been inserted: Pictures can be recorded in
the built-in memory and played back.
• When a card has been inserted: Pictures can be recorded on the
card and played back.
• When using the built-in memory
k
>ð (access indication
¢
)
• When using the card
† (access indication
¢
)
¢ The access indication lights red when pictures are being recorded
on the built-in memory (or the card).
DMC-FS7&FS6PPC-VQT1V73_eng.book 16 ページ ２００８年１２月１日 月曜日 午後５時１０分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
