27
VQT1Q36
Preparation
• Calibration is not done if correct position is not touched. Touch the [i] mark again.
• If you set a different language by mistake, select [~] from the menu icons to set the desired
language.
A Jitter detection demonstration
B Movement detection demonstration
• In playback mode, [JITTER, SUBJ. MOVE DEMO.] cannot be
displayed.
• Press [DISPLAY] to close [JITTER, SUBJ. MOVE DEMO.].
Press [MENU/SET] to close [AUTO DEMO].
• [JITTER, SUBJ. MOVE DEMO.] is an approximation.
• [AUTO DEMO] has no TV output capability.
[CALIBRATION]
Adjust the position of the touch panel if a different thing gets
selected from what you touched or touch operation does not
respond.
1 Press [MENU/SET].
2 Touch the orange [r] mark
displayed on the screen in
order with the stylus pen
(supplied) (5 places).
• A message is displayed once the
position is set.
3 Press [MENU/SET] to finish.
~ [LANGUAGE]
Set the language displayed on the screen.
[ENGLISH]/[DEUTSCH]/[FRANÇAIS]/[ESPAÑOL]/[ITALIANO]/
[ 繁體中文 ]
¢
/[¢]
¢ Not displayed on DMC-FX500P
[DEMO MODE]
Select this to display [JITTER, SUBJ. MOVE DEMO.] or the
camera’s features.
[JITTER, SUBJ. MOVE DEMO.]
[AUTO DEMO]: The camera’s features are displayed as a slide
show.
DEM
A
B
DMC-FX500P_mst.book 27 ページ ２００８年２月２５日 月曜日 午後５時５４分
To Next Page
Loading...
