VQT1Q36
88
Advanced (Playback)
You can add text (comments) to pictures. After text has been registered, it can be included
in prints using [TEXT STAMP] (P92). (Only alphabetic characters and symbols can be
entered.)
You can use the stylus pen (supplied) if it is hard to operate with your fingers.
Enter characters.
• Touch [ ] to switch text between [A] (capitals), [a]
(small case), and [&/1] (special characters/numbers).
• The cursor at the entry position can be moved to the
left with touching [ ], and to the right with touching
[].
• To enter a blank, touch []], or to delete an entered
character, touch [DELETE].
• To stop editing at any time during text entry, touch [CANCEL].
• A maximum of 30 characters can be entered.
Touch [EXIT].
∫ Delete the title
1 In step 4, delete all the texts.
2 Touch [EXIT].
Note
•
Text can be scrolled if all of the registered text does not fit on the screen.
• The name setting of [BABY1]/[BABY2] or [PET] in scene mode can also be registered by using
the operation in steps
4 and following.
• The name setting of [BABY1]/[BABY2] or [PET] in scene mode and [TITLE EDIT] cannot be
registered at the same time.
• You can print out texts (comments) using the “PHOTOfunSTUDIO-viewer-” bundled software on
the CD-ROM (supplied).
• You cannot use titles edit for pictures taken with other equipment.
[TITLE EDIT]
Touch a picture from thumbnail at the bottom of the screen.
Touch [ ].
Touch [TITLE EDIT].
1
2
3
4
5
DMC-FX500P_mst.book 88 ページ ２００８年２月２５日 月曜日 午後５時５４分
To Next Page
Loading...
