- 71 -
Recording
Adjust the flash output when the subject is small, or the reflectivity is very high or low.
Press 3 [È] several times to display [FLASH],
and then press 2/1 to set the flash output.
• You can adjust from [j2 EV] to [i2 EV] in steps of [1/3 EV].
• Select [0 EV] to return to the original flash output.
Press [MENU/SET] to close the menu.
Note
•
When the flash output is adjusted, the flash output value appears on the upper left of the
screen.
• The flash output setting is memorized even if the camera is turned off.
• You cannot set [FLASH] in the following cases.
–In Intelligent Auto Mode
–In [EXPRESSIVE], [RETRO], [HIGH KEY], [SEPIA] and [MINIATURE EFFECT] in Creative
Control Mode
–In [SCENERY]
–In [NIGHT SCENERY], [HANDHELD NITE SHOT] and [ILLUMINATIONS] in
[NIGHT PORTRAIT]
–In [PANORAMA ASSIST], [SUNSET], [FLASH BURST], [STARRY SKY], [FIREWORKS],
[AERIAL PHOTO], [HIGH SPEED VIDEO] and [3D PHOTO MODE] in Scene Mode
–In Creative Video Mode
Adjust the flash output
To Next Page
Loading...
