11. Using the Wi-Fi/NFC Function
302
∫ Writing the location information to the images
(Preparation on the camera)
Connect to a smartphone. (P290)
4 Operate the smartphone.
1 Start “Image App”. (P289)
2 Select [ ].
3 Select [Geotagging].
4 Select [ ] to send and write the location information.
•
Follow the on-screen messages to operate the smartphone.
• Images with location information are indicated with [ ].
• Cautions for Use:
Be sure to pay special attention to the privacy, the likeness rights, etc. of the subject
when you use this function. Use at your own risk.
• The smartphone battery drains faster while location information is being recorded.
When recording of location information is not necessary, stop it.
• On the smartphone, you can set the acquisition interval of location information and check the
transfer status of location information.
Refer to [Help] in the “Image App” menu for details.
Not available in these cases:
•
Location information cannot be written to the following images or in the following situations:
– Images recorded after location information was sent to the camera
– Motion pictures recorded in [AVCHD]
– Images with location information already written to them
– Images protected by [Protect]
– When there is insufficient space left on the card
– When the Write-Protect switch to the card is set to the [LOCK] position
– Images recorded with other devices
To Next Page
Loading...
Need help?
General
