- 33 - VQT3T39
Taking pictures with flash
■
Available types in each mode
(○: Available, –: Not available,
○
: Default setting)
[Scene Mode]
○○
∗
1
○○○– ○ – ○○– ○
○ – ○○––––○ –––
○ – ○○○– ○ – ○○○○
–––––––○ ––––
–––––○ – ○ ––––
○○○○○○○○○○○○
∗
1
Set to , , or according to the subject and brightness.
• The flash cannot be used in Motion Picture Mode and in these Scene Modes:
, , , , .
• Scene Mode flash settings are restored to default when Scene Mode is changed.
■
The available flash range when [Sensitivity] setting is AUTO
W side (Max.) Approx. 0.6 m (1.97 feet) - 4.6 m (15.09 feet)
T side (Max.) Approx. 0.6 m (1.97 feet) - 2.0 m (6.56 feet)
●
The flash is activated twice. Be sure to keep still until all flashing is complete.
●
Shutter speeds are as follows:
• , , , : 1/60 - 1/2000th
• , : 1/8
∗
2
- 1/2000th
∗
2
Varies according to [Intelligent Auto] Mode, [Scene Mode] scene, etc.
●
The effect of Red-Eye Reduction varies depending on the subject and is affected by
factors such as distance to the subject, whether the subject is looking at the camera
during preliminary flash, and so on. In some cases, the effect of Red-Eye Reduction
may be negligible.
●
Do not touch or look at the flash (→7) from close distances (i.e. a few cm).
Do not use the flash at close distances to other subjects (heat/light may damage
subject).
●
Flash settings may be changed when changing Recording Mode.
●
Scene Mode flash settings are restored to default when Scene Mode is changed.
●
When [AUTO] is set in [Sensitivity], the ISO Sensitivity is automatically set in a range up
to 800.
●
No pictures may be taken if these marks (e.g. ) are flashing (flash is charging).
●
Insufficient light may prevent appropriate exposure or white balance.
●
Flash effect may not be fully achieved with high shutter speeds.
●
Flash charging may take time if battery is low, or if using flash repeatedly.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
