- 68 - VQT3T39
Q&A Troubleshooting
LCD monitor
Monitor sometimes shuts off even though power is on.
●
After recording, monitor shuts off until next picture can be recorded.
Brightness is unstable.
●
Aperture value is set while shutter button is pressed halfway.
(Does not affect recorded picture.)
Monitor flickers indoors.
●
If the LCD monitor flickers when you record pictures under lighting such as fluorescent
or LED lighting fixture, use [Light Freq.] in the [Setup] menu to set the utility frequency
of the area where you are using. (→26)
Black/blue/red/green dots or interference appears. Monitor looks distorted when
touched.
●
This is not a fault, and will not be recorded on the actual pictures, so there is no need to
worry.
Date/age is not displayed.
●
The current date and [Age] are displayed for about 5 seconds in instances such as
when the camera is turned on, when you switch from Playback Mode to Recording
Mode, when you switch to [Baby] Scene Mode.
Flash
No flash emitted.
●
Flash set to [Forced Flash Off] (→32).
●
Flash is disabled when using [Burst] or when using the following Scene Modes.
[Scenery], [Panorama Assist], [Night Scenery], [Sunset], [Fireworks]
Playback
Cannot view pictures.
●
Press the Playback button.
●
No pictures in built-in memory or card (pictures are played from card if inserted, from
built-in memory if card is not inserted).
●
Camera set to [Category Selection].
→ Set Playback Mode to [Normal Play] (→48).
Folder/file number displayed as [-]. Picture is black.
●
Picture edited on computer or taken with a different device.
●
Batteries removed immediately after picture taken, or picture taken with low battery.
→ Use [Format] to delete (→28).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
