- 219 -
Others
• Is the mode dial correctly set?
• Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory. (P62)
• The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> If the lens is dirty, turn on the camera, eject the lens barrel (P9) and gently wipe the lens
surface with a soft dry cloth.
• Was this picture taken with the flash at the close range when the zoom was near [W] (1k)?
> Zoom in a little, and then take the pictures. (P54)
• Was this a picture taken in [PIN HOLE] in My Colour Mode?
> Check that the exposure is correctly compensated. (P77)
• Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
> Set the [MIN. SHTR SPEED] (P143) to slower speed.
> Unset the settings of [MULTI FILM] (P126) or White Balance Bracket (P133).
> Set [AUTO BRACKET] (P78), [ASPECT BRACKET] (P79) or [BURST] (P144) to [OFF].
• Has [HI-SPEED BURST] (P100) or [FLASH BURST] (P101) in Scene Mode been set?
• The focus range varies depending on the Recording Mode.
> Set to the proper mode for the distance to the subject.
• The subject is beyond the focus range of the camera. (P45)
• There is camera shake (jitter) or the subject is moving slightly. (P47)
> The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures. (P43)
> When taking pictures at a slow shutter speed, use the Self-timer. (P74)
Recording
The picture cannot be recorded.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
Multiple pictures are taken at one time.
The subject is not focused properly.
The recorded picture is blurred.
The Optical Image Stabilizer is not effective.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
