Advanced (Recording pictures)
- 84 -
[REC] Mode:
Taking Pictures with Manual Focus
Use this function when you want to fix the focus or when the distance between the lens
and the subject is determined and you do not want to activate Auto Focus.
Set the focus selector switch to [MF].
• [ ] is displayed in the upper left of the screen
while in Manual Focus Mode.
Press the rear dial a few times to enable
the Manual Focus operation.
• Enabled operation will switch every time the rear dial
is pressed.
• Manual Focus operation is enabled when [ ] at
the bottom right of the screen changes to orange.
Rotate the rear dial.
• Focus range disappears.
Press 2/1 or rotate the rear dial to focus
on the subject.
A Focus range
• It may be difficult to make fine adjustments when
using the rear dial. If you have any difficulty, we
recommend adjusting using the cursor button.
• Pressing and holding down the cursor button causes
the focus position to move continuously.
• MF assistance disappears about 2 seconds after you
stop operating the cursor button or the rear dial.
• Focus range disappears about 5 seconds after you stop operating the cursor button or
the rear dial.
• During motion picture recording, MF assistance and focus range will not display, but you
can focus by pressing 2/1, or by using the rear dial.
Take the picture.
To Next Page
Loading...
