22
SQW0740
Preparations
Charging battery
●
If the computer enters sleep mode during charging, charging may be stopped.
●
If a notebook computer that is not connected to an electrical outlet is connected to the camera,
the battery of the notebook computer will be depleted. Do not leave the camera and notebook
connected for a long period of time.
●
Always connect the USB connection cable to the USB connector on your computer. Do not
connect the USB connection cable to the USB connector of the monitor, keyboard, printer, or USB
hub.
Charging lamp indications
Charging lamp
On: Charging in progress
Off: Charging complete
(After charging stops, disconnect the camera from
the electrical outlet or your computer.)
Flashing: Charging error
(For instructions on correcting the problem,
refer to (→291).)
Notes on charging time
When using the AC adaptor (supplied)
Charging time Approx. 130 min.
• The charging time indicated above is the time required for charging in case when the
battery is completely used up. The time required for charging differs depending on
conditions of battery usage. Charging takes longer in cases when temperatures are
either high or low and when the battery has not been used for a long period of time.
• The time required for charging through the computer varies depending on the power
supply capacity of the computer.
●
Do not use any other USB connection cables except the supplied one. Doing so may cause
malfunction of the camera.
●
Do not use any other AC adaptors except the supplied one.
●
Do not use a USB extension cable.
●
The AC adaptor (supplied) and the USB connection cable (supplied) are dedicated accessories of
this camera. Do not use them for other devices.
●
Remove the battery after use. (The battery will be exhausted if left for a long period of time after
being charged.)
●
If there is any trouble related to the electrical outlet (i.e. power failure), charging may not complete
properly. Disconnect the USB connection cable (supplied) and reconnect it to the camera.
●
If the charging lamp does not light even when the camera is connected to the AC adaptor
(supplied) or a computer, check to make sure it is properly connected. (→21)
To Next Page
Loading...
Need help?
General
