14 VQT1B61 VQT1B61 15
Preparations
2
Inserting battery and card
Preparations
1
Charging battery
Always charge before first use! (not sold pre-charged)
Note
Battery will be warm during charging and for some time thereafter.
Battery will run out if not used for long periods of time, even after being charged.
Battery can be topped up even if not fully depleted.
Do not disassemble or modify the charger.
Please purchase a new battery if battery life becomes significantly reduced.
Approximate battery life
Number of pictures:
270 [300
2
] (at 30-sec intervals)
1
(equivalent to approx. 135 [150
2
] mins)
1
Values based on CIPA standards. (P.91)
(Number reduced if intervals longer – 67 [75
2
] pictures if 2-minute intervals)
Playback time: Approx. 260 [280
2
] mins
Above figures may be reduced if intervals between recording are longer; if flash, zoom,
or POWER LCD are used frequently; or in colder climates (depends on actual usage).
2
DMC-TZ2
Battery
(check orientation)
Card
(check orientation)
Do not touch
connector
Caution
Always use genuine Panasonic batteries.
If you use other batteries, we cannot guarantee the quality of this product.
Do not remove card or battery while power is ‘ON’ or while status indicator is on
(Camera may cease operating correctly, or card/recorded contents may be damaged).
The reading/writing speed of a MultiMediaCard is slower than an SD memory card. When a
MultiMediaCard is used, the performance of certain features may be slightly slower than advertised.
Keep the Memory Card out of reach of children to prevent swallowing.
Compatible memory cards (sold separately)
The following SD standard-based cards (Panasonic brand
recommended)
● SD memory cards, 8MB-2GB
● SDHC memory cards (4GB) → (P.96)
(4GB (or greater) cards without the SDHC logo are not of SD standard.)
→ For recording picture/time capacity, see (P.92)
→ For model numbers and types,
see http://panasonic.co.jp/pavc/global/cs (This Site is English only.)
MultiMediaCards (still images only)
Set the camera ON/OFF switch to
OFF
Slide to the ‘OPEN’ position and
open the lid
Completely insert battery and card
(both click into place)
Close lid
Slide to the ‘LOCK’ position.
OPEN
LOCK
To remove
To remove battery,
move lever in direction
of arrow.
lever
To remove card,
press down in center.
Battery (model-specific)
Charger
(model-specific)
Indoor electrical outlet
(charge at room temperature of 10-
35°C (50°F-95°F))
Connect to charger.
(Ensure ‘LUMIX’ faces outwards.)
Fold out pins and
plug into electrical outlet.
Disconnect charger and
battery when charging is
complete.
Charging light (CHARGE)
On: Charging in progress (approx. 120 min.)
Off: Charging complete
If light is flashing…
● Battery temperature is too high/too low → Battery may still be charged, but it will
take longer as it must adjust to the room temperature.
● Battery/charger connector is dirty → clean with dry cloth.
plug
Status indicator
SDHC logo
SDHC memory
card
To Next Page
Loading...
Need help?
General
Weight and Dimensions
