VQT4P25
Preparations
Charging battery
- 11 -
[OPEN] [LOCK]
Release lever
Inserting the battery
To charge the battery, insert it into the camera.
Slide to the [OPEN] position
and open the card/battery
door
Insert the battery all the way
• Make sure to insert the battery in the
correct orientation.
• Insert the battery all the way firmly
and check that it is locked by lever.
Close the card/battery door
• Slide to the [LOCK] position.
Lever
■
To remove battery
Move the lever in the card/battery
compartment in the direction of the arrow.
●
Always use genuine Panasonic batteries.
●
If you use other batteries, we cannot guarantee the quality of this product.
●
Remove battery from camera after use.
●
To remove the battery, turn the camera off and wait until the LUMIX indicator on the
LCD monitor goes off. (Failure to wait may cause the camera to malfunction and may
damage the card or recorded data.)
To Next Page
Loading...
