Panasonic Lumix DMC-TZ5P - Page 18

18
Attribute Main item Sub item Error code Contents (Upper)
High 4bits Low 4 bits Check point (Lower)
LENS Lens drive OIS 18*0 1000 PSD (X) error. Hall element (X axis) position detect error in OIS unit.
OIS Unit
2000 PSD (Y) error. Hall element (Y axis) position detect error in OIS unit.
OIS Unit
3000 GYRO (X) error. Gyro (IC7101: X axis) detect error on Main P.C.B..
IC7101 (Gyro element) or IC6001 (VENUS 4)
4000 GYRO (Y) error. Gyro (IC7101: Y axis) detect error on Main P.C.B..
IC7101 (Gyro element) or IC6001 (VENUS 4)
5000 MREF error (Reference voltage error).
IC9101 (LENS drive) or IC6001 (VENUS 4)
6000 Drive voltage (X) error.
VENUS 4 AD value error, LENS Unit, LENS flex breaks etc.
7000 Drive voltage (Y) error.
VENUS 4 AD value error, LENS Unit, LENS flex breaks etc.
C.B./Zoom 0010 HP Low detect error. (HP ENC. detects always low. (Fully retracted con-
nection.))
Zoom motor, ABS ENC., and/or circuit failure. Zoom deadlock (Exit
side).
0020 HP Low detect error. (HP ENC. detects always high. (Exit connection.))
Zoom motor, ABS ENC., and/or circuit failure. Zoom deadlock (Retract
side).
0030
0040
0050
Zoom ENC. detect error. (No signal is supplied from Encoder located on
Zoom Motor.)
Zoom motor, ABS ENC., and/or circuit failure Zoom deadlock.
Focus 0001 HP Low detect error (Focus encoder always Low detect error).
FP9001-(33) signal line or IC6001 (VENUS 4)
0002 HP High detect error (Focus encoder always High detect error).
FP9001-(41) signal line or IC6001 (VENUS 4)
Lens 18*1 0000 Power ON time out error.
Lens drive system
18*2 0000 Power OFF time out error.
Lens drive system
Adj.History OIS 19*0 2000 OIS adj. Yaw direction amplitude error (small)
3000 OIS adj. Pitch direction amplitude error (small)
4000 OIS adj. Yaw direction amplitude error (large)
5000 OIS adj. Pitch direction amplitude error (large)
6000 OIS adj. MREF error
7000 OIS adj. time out error
8000 OIS adj. Yaw direction off set error
9000 OIS adj. Pitch direction off set error
A000 OIS adj. Yaw direction gain error
B000 OIS adj. Pitch direction gain error
C000 OIS adj. Yaw direction position sensor error
D000 OIS adj. Pitch direction position sensor error
E000 OIS adj. other error
HARD VENUS A/D Flash 28*0 0000 Flash charging error.
IC6001-(AC17) signal line or Flash charging circuit
FLASH ROM
(EEPROM
Area)
FLASH ROM
(EEPROM
Area)
2B*0 0001 EEPROM read error
IC6002 (FLASH ROM)
0002 EEPROM write error
IC6002 (FLASH ROM)
SYSTEM RTC 2C*0 0001 SYSTEM IC initialize failure error
Communication between IC6001 (VENUS 4) and IC9101 (SYSTEM)