Panasonic Lumix DMC-TZ5P - 9 Measurements and Adjustments; 9.1. Part Replacement and Adjustment Matrix

38
9 Measurements and Adjustments
9.1. Matrix Chart for Replaced Part and Necessary Adjustment
The relation between Replaced part and Necessary Adjustment is shown in the following table.
When concerned part is replaced, be sure to achieve the necessary adjustment(s).
As for Adjustment condition/procedure, consult the “Adjustment Manual” which is available in Adjustment software.
The Adjustment software is available at “TSN Website”, therefore, access to “TSN Website” at “Support Information from NWBG/
VDBG-PAVC”.
NOTE:
After adjustments have been terminated, make sure to achieve “INITIAL SETTINGS”.
*1 This adjustment is necessary, not only replacing CCD unit but also removing it from the lens unit.
NOTE:
*There is no LCD adjustment in this model.
Replaced Part
Adjustment Item Main P.C.B. VENUS
(IC6001)
Flash-ROM
(IC6002)
Lens Part
(Excluding
CCD)
CCD Unit
Camera
Section
OIS hall element adjustment
(OIS)
OOOO -
Back focus adjustment
(BF)
OOOO
O
*1
Shutter adjustment
(SHT)
OOOOO
ISO sensitivity adjustment
(ISO)
OOOOO
AWB adjustment
High brightness coloration inspection
(WBL)
OOOOO
CCD white scratch compensation
(WKI)
OOO -
O
*1
CCD black scratch compensation
(BKI)
OOO -
O
*1