HELPFUL INFORMATION
Auto Operation Button
■ Automatic Operation
•
If the remote control fails to function or misplaced,
press Auto Operation button for Automatic operation.
• The Automatic operation will be activated immediately once the Auto
operation button is pressed. However, temperature cannot be adjusted
in this operation.
• The power LED on the indoor unit blinks until the operation mode is
selected automatically.
• To cancel this operation, press once more.
■ Remote Control Signal Receiving Sound
• To switch off the beep (Signal Receiving Sound), press this Auto
Operation button for 10 seconds continuously or longer.
“Beep”, “beep” sound will be heard at the tenth seconds.
Note: “Beep” sound will be heard at the fifth seconds;
However please press continuously until you heard “beep”,
“beep” sound.
• Repeat this, if you want to switch on the Signal Receiving Sound.
* Note: If you press this button continuously for 5 to 10 seconds, Test Run
operation will be performed. A “beep” sound will be heard at the fifth
seconds, to identify the starting of Test Run operation.
(This is for Servicing purpose only.)
Auto Restart Control
• If power is resumed after a power failure, the operation will restart
automatically after 3 - 5
1
/2 minutes.
• Operation will be automatically restart under the previous operation mode
and airflow direction when power is resumed as the operation is not stopped
by remote control.
Timer Setting
• When power failure occurs, the timer setting is cancelled. Once power is
resumed, reset the timer.
Thunder and Lightning
• This air conditioner is equipped with a built-in surge
protective device. However, in order to further protect your
air conditioner from being damaged by abnormally strong
lightning activity, you may switch off the main power supply
and unplug from power socket.
POWER FAILURE
POWER
ECONOMY
POWERFUL
SLEEP
TIMER
To Next Page