5.2. Dust cover assembly removal
1. Separate the upper and lower bodies.
2. Push the salient with a flat-blade screwdriver to remove it
while the upper body is turned over. Pull and remove the
dust cover.
* Salient position
5.3. Motor removal
1. Lift the motor to remove it from the lower body.
2. Remove the ancillary components around the fast-on
terminal connected to the motor.
3. Motor ancillary component removal
Remove the front and rear motor support rubber and noise
suppressor, etc., and replace the motor.
4. Assembling
Take the revers order of removing procedure.
8
MC-E7111-AE79 / MC-E7111-AE7A / MC-E7111-RE79 / MC-E7111-RW79 / MC-E7111-AW79 / MC-E7113-RE79 / MC-E7113-RW79
To Next Page
Loading...
