Wash
in water
13
ENGLISH
/
When suction power weakens
It can also be washed with water
when you are concerned about grime
(Dry it sufficiently then put it back in)
Diligently throw away
debris, and clean it out!
●Do not use detergent, benzine, thinner, alcohol, etc.
(May lead to cracks and discolouration)
●Leave it in a well-ventilated place for about
24 hours, and let it thoroughly dry.
(Not doing so can cause it to smell and get
clogged up)
●
Do not expose to hot airflow from a hairdryer and the
like.
（
May lead to deformation and failure
）
Request
Lightly tap on it to remove debris
and dust
Wipe away the dust on its
surfaces with tissues
●
Install in the reverse sequence of disassembly
●
If the dust box is not securely set in,
it will not suck in the debris.
2
Install the cyclone
unit and mesh filter
into the dust cup
3
Attach the dust box to the main unit
●Be sure to put the backflow
prevention rubber inside the dust cup.
(Not doing so can cause debris to not get sucked up)
1
Fit the pipe into the ring,
and install the net filter
Tab
(inside)
Recess
②
Insert the net filter tabs
(4 places) into the ring’s
recesses.
③
Turn the ring in the
“Lock” direction
Wash it with
running water
Dry it
Immerse it
in water
①
Firmly push it all the way in
①
②
Backflow prevention
rubber
To Next Page
Loading...
