EasyManua.ls Logo

Panasonic MC-UL710 - CAUTION for AC MAINS LEAD (UK and Republic of Ireland Only)

Panasonic MC-UL710
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
This appliance is supplied with a moulded
three pin plug for your safety and
convenience.
A 13-amp fuse is fitted in this plug.
Should the fuse need to be replaced please
ensure that the replacement fuse has a
rating of 13 amps and that it is approved by
ASTA or BSI to BS1362.
Check for the ASTA mark
or the BSI
mark
on the body of the fuse.
If the plug contains a removable fuse cover,
you must ensure that it is refitted when the
fuse is replaced.
If you lose the fuse cover, the plug must
not be used until a replacement cover is
obtained.
A replacement fuse cover can be purchased
from your local Panasonic Dealer.
WARNING
IF THE FITTED MOULDED PLUG IS
UNSUITABLE FOR THE SOCKET
OUTLET IN YOUR HOME THEN THE
FUSE SHOULD BE REMOVED AND
THE PLUG CUT OFF AND DISPOSED
OF SAFELY.
THERE IS A DANGER OF SEVERE
ELECTRICAL SHOCK IF THE CUT OFF
PLUG IS INSERTED INTO ANY 13-AMP
SOCKET OUTLET.
If a new plug is to be fitted, please observe
the wiring code as shown below.
If in any doubt, please consult a qualified
electrician.
IMPORTANT:
The wires in this mains lead are coloured in
accordance with the following wiring code.
Blue: Neutral -
Brown: Live -
As the colours of the wire in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in the plug, proceed as follows.
The wire which is coloured BLUE must -
be connected to the terminal in the plug
which is marked with the letter N or
coloured BLACK.
The wire which is coloured BROWN -
must be connected to the terminal in the
plug which is marked with the letter L or
coloured RED.
WARNING
Under no circumstances should either
of these wires be connected to the
earth terminal of the three pin plug,
marked with the letter E or the Earth
Symbol
Replacing the fuse
The location of the fuse differs according to
the type of plug of the supplied mains lead
as follows.
Open the fuse cover with a
1
screwdriver.
Replace the fuse and close or attach 2
the fuse cover.
CAUTION FOR AC MAINS LEAD
(UK and Republic of Ireland only)
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.
Type A Type B
Type A Type B
4
UL710.indd4UL710.indd4 2012/02/239:21:072012/02/239:21:07

Related product manuals