20
5.7. Blender Jar Complete (PC Jar / SS Jar) / Mill Cup Complete / Chutney
Jar Complete
1. Set the Spatula to the Cutter assemble, insert the long-
nose pliers into the holes of the Connector Insert (upper),
turn it as shown in the picture and take out the blade.
2. Remove Cutter assemble, Shaft assembly, Washer B, Spacer, Washer C and Connector Insert (upper).
• As the Chutney Cutter assembly consists of Cutter and Shaft integrally, they cannot be separated.
• The number of the Washer B differs in Blender Jar Complete, Millcut Complete, and Chutney Jar Complete.
Assembly Instructions
Refer to the picture, and pay attention to the order and the number of Washer B, Spacer, Washer C when you assemble.
To Next Page
