Panasonic MX-EX1031

EN4
●
Do not use the appliance outdoors.
●
Do not drop the appliance or attachments to avoid damaging it.
●
Do not wrap the power cord around the motor housing.
●
Make sure the parts or attachments are set rmly before use.
●
Do not operate the appliance without ingredients.
●
Be sure the mill gasket is attached properly to prevent leakage. (MX-EX1011, MX-EX1031 only)
●
Do not blend or place over 60 °C ingredients into the blender jug.
●
Do not put any liquids or wet ingredients into mill container. (MX-EX1011, MX-EX1031 only)
●
Do not open the lid and put your ngers or utensils such as spoon or fork into the blender
jug while the appliance is operating.
●
Do not stretch the gasket to avoid deforming.
●
Do not replace any parts of the appliance with non-genuine spare parts.
●
Do not carry the appliance by holding the power cord, blender jug or mill container.
●
Do not insert any object in the gaps of the appliance.
●
Do not blend more than the working capacity marked on the blender jug.
For the mill container, do not place more than the maximum quantity (MX-EX1011, MX-
EX1031 only). (P. EN8 "Specications")
●
Do not use prohibited ingredients as stated in this instructions. (P. EN5)
●
Do not push the safety lock pin with any implement such as thin stick, etc. (P. EN7)
●
Unplug the plug when the appliance is not in use.
●
Make sure to hold the power plug when unplugging it. Never pull on the power cord.
●
Beware not to trip over or get caught in the power cord while in use.
●
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and o󰀨 by the utility.
●
Care shall be taken when handling the sharp blades, emptying the blender jug, mill
container and during cleaning. Do not clean the blender blade or mill blade by bare hand.
●
Always disconnect the appliance from the supply if it is left unattended and before
assembling, disassembling, moving or cleaning.
●
Switch o󰀨 the appliance and disconnect from supply before changing attachments or
approaching parts that move in use.
●
Ensure to operate and rest the appliance as stated on specication table. (P. EN8
"Specications")
●
Ensure to clean the appliance especially surfaces in contact with food after use. (P. EN7
"Cleaning and Care")
●
This product is intended for household use only.
Important Information
CAUTION
Safety Precautions
Please make sure to follow
these instructions.
VZ50V324_MX-EX1001_MX-EX1011_EX1031 (EN+VN+TH).indd 4VZ50V324_MX-EX1001_MX-EX1011_EX1031 (EN+VN+TH).indd 4 2021/11/11 14:29:572021/11/11 14:29:57