Panasonic MX-EX1031

EN8
Blender & Dry
mill
Even turn to "1"
position, the
appliance
does not start
blending.
●
The blender jug / mill container is not set properly.
➝
Make sure to align the marks on blender jug / mill container and motor housing, then twist
it firmly until you hear a "click" sound.
●
The mill container base is not assembled tightly. (MX-EX1011, MX-EX1031 only)
➝
Assemble it tightly. (P. EN6)
●
The protection device of overload or overheating is activated.
➝
Refer to “Overload and Overheating Protection” for inspection. (P. EN7)
●
The power plug is disconnected.
➝
Insert the power plug into outlet firmly.
Rotation stops
abruptly.
●
The protection device of overload or overheating is activated.
➝
Refer to “Overload and Overheating Protection” for inspection. (P. EN7)
There is abnormal
noise or vibration
increases.
●
Too much ingredients.
➝
Reduce ingredient amount.
●
The mill container base is not assembled tightly. (MX-EX1011, MX-EX1031 only)
➝
Assemble it tightly. (P. EN6)
The ingredient is
leaking.
(MX-EX1011, MX-
EX1031 only)
●
The mill container base is not assembled tightly.
➝
Assemble it tightly. (P. EN6)
●
The mill gasket is not attached or attached loosely.
➝
Attach it properly.
●
Foreign matters are attached to the mill gasket.
➝
Remove them.
●
The mill gasket is damaged.
➝
Contact Panasonic Service Centre to replace it.
Blender
The blade is idling.
●
The liquid amount is not enough.
➝
Add more liquid.
●
Too much ice cubes.
(e.g. juice with a lot of ice)
➝
①
Remove blender jug after rotation stop completely.
②
Shake the blender jug gently.
When the blender is used
When the dry mill is used
(MX-EX1011, MX-EX1031 only)
Power supply
220
-
240 V 50
-
60 Hz
Power consumption
230
-
260
W
Rated time
Continuous operation
(Repeat the cycle
of 3 minutes ON and then 1 minute OFF)
Continuous operation
( Repeat the cycle
of 1 minute ON and then 2 minutes OFF )
Working capacity
(approximately)
1 000
mL
50
g
Dimensions
(approximately)
W
173
mm
148
mm
D
161
mm
161
mm
H
353
mm
257
mm
Mass. (approximately)
1.5
kg
1.3
kg
Check following points before calling or arranging for repair.
Problem Cause and Action
Troubleshooting
Specications
VZ50V324_MX-EX1001_MX-EX1011_EX1031 (EN+VN+TH).indd 8VZ50V324_MX-EX1001_MX-EX1011_EX1031 (EN+VN+TH).indd 8 2021/11/11 14:30:032021/11/11 14:30:03