Panasonic MX-EX1031

EN6
How to use the scraper
● It can be inserted through the lid opening while blending without
interfering with the blender blade.
● Slide the scraper through the lid opening and scrape to remove food sticking to blender jug sides.
● To avoid ingredients splattering, it is recommended to insert the scraper from the lid opening
when using blender jug.
Scraper is useful when
● too little liquid makes ingredients hard to blend. (e.g. for dips, sauces, curry dishes)
● ingredients stick to the inner side of container. (e.g. garlic, chile pepper)
4
When blending is completed,
turn the rotary switch to
" 0 " position to switch off. Unplug.
Turn the blender jug
anticlockwise to remove it,
open the lid and take out
the ingredients.
3
1
2
4
①
Align the ▲ on the motor
housing with the
▽
on the mill
container.
②
Twist mill container clockwise
until you hear a click sound.

Mill container only can be attached
by above steps.
4
When grinding is completed,
turn the rotary switch to
" 0" position to switch off. Unplug.
Turn the mill container
anticlockwise to remove it,
open the mill container, and
take out the ingredients.
1
Turn the mill container upside down and place the
ingredients in it. Twist the mill container base
clockwise until you hear a click sound.
2
Attach blender jug to the motor housing.
Blender Dry mill
(MX-EX1011, MX-EX1031 only)
1
Place the ingredients into blender jug, and then close the lid.
To disassemble
Turn anticlockwise
● Pour liquid first, followed by soft ingredients and then others.
(i) Liquid (ii) Soft ingredients (iii) Hard ingredients (iv) Ice cubes
①
Align the ▲ on the motor
housing with the
▽
on the
blender jug.
②
Twist blender jug clockwise
until you hear a click sound.

Blender jug only can be attached
by above steps.
3
Plug in. Hold the blender jug, and then turn the rotary
switch to " 1 " position to start.
● If the appliance stops
during operation. (P. EN8)
● If the appliance stops during
operation. (P. EN8)
2
Attach the mill container to the motor housing.
3
Plug in. Hold the mill container, and then turn the rotary
switch to "1" position to start.
How to Use
To assemble
Turn clockwise
Make sure the mill
gasket is not damaged
and placed properly
before assemble.
1
2
1
2
3
1
2
3
1
2
3
4
2
1
2
1
1
2
VZ50V324_MX-EX1001_MX-EX1011_EX1031 (EN+VN+TH).indd 6VZ50V324_MX-EX1001_MX-EX1011_EX1031 (EN+VN+TH).indd 6 2021/11/11 14:30:012021/11/11 14:30:01