EN7
The safety lock has been designed to prevent the blender from
switching on when blender jug or mill container is not properly in place.
●
Unplug before cleaning.
●
Clean the parts thoroughly after every use. Keep all parts clean and dry always.
●
Do not wash any part of the appliance in the dishwasher.
●
Do not use benzine, thinner, bleach, alcohol, nylon face of sponge, metal brushes or polish powder etc.
●
Some discoloration of the plastic parts may occur upon usage but it does not affect usage.
In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
●
Do not use the appliance repeatly without any countermeasure.
1
Turn the rotary switch to "0" position, unplug the appliance.
2
Remove blender jug or mill container from motor housing.
Reduce the ingredients to less than half. (For blender jug, it also can add liquid.)
●
Remove the prohibted ingredient if used.
3
Reset the blender jug or mill container, start blending again.
(P. EN 6)
If the appliance still does not operate after performing the above, overheating protection has been activated.
Turn the rotary switch to "0" position, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a
normal temperature) to release overheating protection before using again.
(If appliance still does not operate, contact Panasonic Service Centre for inspection or repair.)
Safety lock pin
Cleaning and Care
Safety Lock
Overload and Overheating Protection
Motor housing
Wipe motor housing with a damp cloth.
Containers and other parts
Wash each part in cold or lukewarm water with a soft sponge.
Carefully clean blades with a brush.
Rinse and dry thoroughly.
(Brush is not provided.)
●
Remove the mill gasket before washing.
Mill container base
Carefully clean blades with a brush. Do not use water.
(Brush is not provided.)
Blender jug prewash
Add 400 mL clean water into the blender jug, plug in and blend for
about 1 minute.
Storing
●
Assemble the mill container base with the mill container. (MX-
EX1011, MX-EX1031 only)
●
Dry the lid thoroughly, then keep it separately.
VZ50V324_MX-EX1001_MX-EX1011_EX1031 (EN+VN+TH).indd 7VZ50V324_MX-EX1001_MX-EX1011_EX1031 (EN+VN+TH).indd 7 2021/11/11 14:30:022021/11/11 14:30:02
To Next Page
Loading...
