Panasonic MX-V310

EN10
After Use
Cleaning
■Note:
• During prewash, do not fi ll in the normal water more than the amount indicated. It may cause high vibration.
• After prewash, unplug the appliance before cleaning. Handle the Cutting Blades and glass parts carefully during
cleaning.
• Wash with diluted dish soap (neutral) and a soft sponge. After washing, be sure to rinse and wipe dry thoroughly.
• Do not use benzene, thinner, alcohol, bleach, polishing powder or metal brush to clean the appliance. The surface
may be damaged.
• Do not place the appliance in the dishwasher or the dish dryer for cleaning.
• Some discolouration of the plastic parts may occur upon usage but it does not affect usage.
• Make sure to clean the appliance after every use.
Storing
■Note:
• Do not wrap the Cord around the Motor Housing.
• Mount the Blender Jug onto the Blender Jug Base and store it.
• Mount the Mill Container onto the Mill Container Base and store it.
• Wipe the Motor Housing with a damp cloth.
• Clean the Cutting Blades with a brush under running water.
Do not use hand to clean the Cutting Blades.
* Brush is not provided.
Prewash
• For Blender, fi ll in 750 mL of normal water. Press
P2
while holding the
Blender Jug by hand and operate for 3 to 10 times for cleaning.
• For Wet & Dry Mill, fi ll in 100 mL of normal water. Press
P2
while
holding the Mill Container by hand and operate for 3 to 10 times for
cleaning.
1500
1000
500
Wash
• Before cleaning, make sure to take out the Blender Gasket
and the Mill Gasket.
Wiping
Blender_MX-V310_300 (EVT).indb 10Blender_MX-V310_300 (EVT).indb 10 11/28/2017 6:31:09 PM11/28/2017 6:31:09 PM