Panasonic MX-V310

Before Use
EN5
English
ڦ Wash each part before using the appliance for the fi rst time.
■Note:
• Place your thumb on the Rib when assembling or disassembling the Blender Jug or
Mill Container to its Base for easier turning.
Rib
To Disassemble
Blender
Turn the Blender Jug Base
clockwise to disassemble.
• Be careful with the Blender
Cutting Blade.
Pull up the Blender Jug to
release from the Blender Jug
Base.
1500
1000
500
Mill
Turn the Mill Container
upside down and turn the Mill
Container Base anticlockwise
to disassemble.
• Be careful with the Mill Cutting
Blade.
Pull up the Mill Container Base
to release the Mill Container.
To Assemble
Blender
Place the Blender Gasket to
the Blender Jug Base.
• If the Blender Gasket is not
placed, it will cause leakage.
Follow the assembly
sequence in the direction
of arrow as illustrated.
Attach the Blender Jug to
the Blender Jug Base and
tighten the Blender Jug Base
anticlockwise to assemble.
• Ensure that the Blender Gasket
is set properly and the Blender
Jug is tightened securely.
Otherwise, it may cause leakage.
• Do not attach or remove the
Blender Jug after the Blender
Jug Base is placed on the Motor
Housing. The liquid will leak or
the motor will not operate.
1500
1000
500
Mill
Turn the Mill Container upside
down.
Place the Mill Gasket to the
Mill Container.
• If the Mill Gasket is not placed,
it will cause leakage.
Attach the Mill Container
Base to the Mill Container and
tighten the Mill Container Base
clockwise to assemble.
• Make sure that the groove of the
Mill Gasket is fi tted properly on
the edge of the Mill Container.
Otherwise, it may cause
leakage.
• Do not attach or remove the
Mill Container after the Mill
Container Base is placed on
the Motor Housing. The liquid
will leak or the motor will not
operate.
Mill Container
Mill Gasket
Control Panel
* Use this function for intermittent operation until the required blending texture is obtained.
P1 P221
Pudding
Baby Food
Soup
Juice/Smoothie
Peanuts Crush
Ice Crush (MX-V310 only)
Cleaning
Off Speed 1 Speed 2 Pulse 1*
(Low speed pulse)
Pulse 2*
(High speed pulse)
Blender_MX-V310_300 (EVT).indb 5Blender_MX-V310_300 (EVT).indb 5 11/28/2017 6:30:59 PM11/28/2017 6:30:59 PM