Panasonic NA-120VX7

Questions and Answers:

K
Keith ParkerSep 3, 2025
Why is there not enough or too much foam in my Panasonic NA-120VX7 Washer?
- L
  Luke CrawfordSep 3, 2025
  The amount of foam in your Panasonic Washer can vary depending on factors like the water's temperature, level, and softness. Less foam can result from putting powdered detergent directly into the drum instead of the detergent drawer, using too little detergent, using a low foam detergent, or washing heavily soiled laundry or a large load. More foam can result from using too much detergent.
D
Douglas AvilaSep 1, 2025
Why is my Panasonic NA-120VX7 making an unusual noise or vibration?
- K
  Kristin GuerreroSep 2, 2025
  An unusual noise or vibration in your Panasonic Washer could be due to a metal item in the drum, or the appliance may be installed on a slope or an unstable surface. Another possibility is that wet clothes may be loaded at the start of washing. In this case, perform spin process or wring out the laundry beforehand.
C
Christopher BrownAug 31, 2025
What to do if buttons do not work on my Panasonic Washer?
- E
  Edward RogersAug 31, 2025
  If the buttons on your Panasonic Washer aren't working, it could be because settings cannot be changed while an operation is in progress. Only the spin speed and “Extra Rinse” settings can be adjusted when the wash process is paused. Also, the Child Lock may be activated.
J
Jennifer LynnAug 29, 2025
What happens if the circuit breaker trips during operation of my Panasonic Washer?
- J
  Joseph BaileyAug 29, 2025
  If the circuit breaker trips during operation of your Panasonic Washer, figure out the cause and deal with it, then reset the breaker. Operation will resume from the point it had stopped when the power is recovered (Auto restart).
C
Christina ClarkeAug 27, 2025
What happens if there is a power cut during operation of my Panasonic NA-120VX7 Washer?
- I
  ihuberAug 28, 2025
  If there is a power cut during operation of your Panasonic Washer, the operation will resume from the point it had stopped when the power is recovered (Auto restart).
W
William RobertsAug 27, 2025
Why does the drum stop and rotate several times during the spin process of my Panasonic Washer?
- C
  cynthiabradleyAug 27, 2025
  During the spin process, the drum of your Panasonic Washer may stop and rotate several times because the appliance detects an unbalanced load and automatically tries to correct it. The laundry may also be too light; try adding one or two bath towels.
K
Keith HernandezAug 25, 2025
Why is no water going into my Panasonic Washer?
- D
  David ReyesAug 25, 2025
  No water may be entering your Panasonic Washer because the tap is turned off, the water supply is disrupted, the water supply hose is frozen or the water supply filter may be blocked.
A
Amber ChavezAug 23, 2025
Why does water drain out during a wash in my Panasonic NA-120VX7 Washer?
- B
  Brett LopezAug 23, 2025
  If water drains out during a wash cycle in your Panasonic Washer, it could be due to the foam detection function, where excess foam triggers water drainage and fresh water intake to remove the foam. Also, even if water is directly supplied to the drum, it may drain away without building up.