Maintenance (continued)
30
Wash the detergent drawer with water.
A build-up of detergent can develop
mould.
1 Pull out the detergent drawer.
2 Remove the softener cover.
3 Wash the detergent drawer with
water.
4 Replace the softener cover and
detergent drawer.
Use a soft cloth to wipe off any water or
dirt.
NOTE
● Do not splash water.
■Door seal and window
Wipe off any lint or foreign objects.
■Appliance
Wipe with a cloth and mild kitchen
detergent.
Once a month, run the “Cotton”
programme at 60 °C without anything
inside the drum. This will reduce
bacteria and prevent odours.
NOTE
● If you use a tub cleaning detergent
or bleach, put about 30 ml into the
detergent compartment of the
detergent drawer. (P. 12)
● If you use a scale remover, follow
the manufacturer’s instructions.
Detergent drawer
Window
Drain filter
Drum
Tap
Mains plug
Door seal
Detergent drawer
Appliance
Drum
31
Maintenance
Remove lint from the drain filter once a
month. A build-up of lint can hamper
drainage.
1 Switch off and unplug the appliance.
2 Open the drain filter cover with a
flat-blade screwdriver, and remove
the cover.
3 Pull out the funnel, and place a
container to collect the drainage
water.
4 Turn the drain filter slowly to loosen
it so as not to discharge large
amounts of water at a time.
5 Pull the drain filter out.
6 Remove any lint and debris.
7 Turn the drain filter to tighten it until
it stops. (two rotations)
8 Attach the drain filter cover.
Drain filter
CAUTION
Do not remove the drain filter if
there is water inside the drum, such
as during operation. If you do, a
large volume of water (possibly
scalding water) will pour out.
Drain filter cover
Funnel
Container
Drain filter
To Next Page
Loading...
