ProcedureFigure
(TH4 detects water temperature in the drum)
After lay down the washing machine on it left side
and remove the hole cover,
1.Remove the two screws mounting the thermistor-4.
Note:
Please spread a cloth to prevent scratch on the body.
2.Remove one connector from the thermistor-4.
3.Pull out the thermistor-4.
After remove the rear panel
1.Remove the cover and the two connectors.
2.Remove one nut mounting the heater unit by the
box wrench (size 10mm) and remove a earthwire.
3.Release another nut slightly, and push the nut
inside by the box wrench, and pull it out to remove.
1.Remove all screws mounting the rear panel.
2.Remove the rear panel.
-35-
21 Replacement
of the thermistor-4
22 Replacement
of the heater unit
23 Replacement
of the belt
NA-16VX1/16VG1/14VA1
Description
To Next Page
Loading...
