Panasonic NA-16VX1

ProcedureFigure
3.Turn the large pulley and remove the belt outward.
After remove the rear panel lay down the washing
machine on it left side and remove the hole cover,
1.Remove the insulation cover .
2.remove the connector.
3.Remove the two bolts mounting the motor by the
box wrench (size 10mm).
4.Pull out the motor.
After remove the rear panel
1.Insert the two holes of the pulley with special tool
(Parts No . JF066), then loosen the nut with spanner
as shown in left figure .
2.Remove the belt.
3.Remove the nut and gasket.
4.remove the pulley.
-36-
24 Replacement
of the Motor
25 Replacement
of the Pulley
NA-16VX1/16VG1/14VA1
Description