Panasonic NA-D106X1

27
NA-D106X1
8.2.2. Replacement of Lead wire cover
1. Open the Door, remove the 1 Lead wire cover mounting
screw and remove the Lead wire cover.
8.2.3. Replacement of Controller
(Display side)
1. After performing the procedures for Replacement of Lid
sash (8.2.1) and Replacement of Lead wire cover (8.2.2),
remove the Clamping band and connectors in the Lead
wire cover (blue and white).
2. Remove the 3 mounting screws from the controller
(Display side).
3. While pulling the lever of the Controller (Display side)
upward, slide it to the side to remove.
*During assembly, set the Lid sash at the end. (The Lid
sash can be set only at the end).
Caution
At the time of failure diagnosis and parts replacement,
please be sure to ground yourself.
• Not doing so may a cause a malfunction due to static
electricity.
• Eliminate the potential difference by touching the ground
and the power plug.