Panasonic NA-D106X1

37
NA-D106X1
8.8.3. Replacement of Body band B
1. Use the longnose pliers to remove the Body band B.
Refer to the figure below (the same disassembly procedure on both the front and rear sides).
8.8.4. Body band B (front side, back side) 8.8.5. Replacement of Body support D
and Lid hinge U
1. After performing the procedures for Replacement of Body
B (8.8.1), Replacement of Door lock switch (8.8.2),
Replacement of Body band B (8.8.3), remove the 1
nozzle fixing screw (refer to Replacement of Nozzle and
Detergent case A (8.7.3)), the 1 Clamping band fixing the
lead wire for Door lock switch, 8 Clamping bands fixing
the Connector lead wire and 4 Body support D fixing
screws.
*The Lid hinge U can be replaced even before the Body
support D is removed.
Remove the 3 fixing screws (in each part).