Panasonic NA-D106X1

33
NA-D106X1
4. Remove the 1 fixing screw securing the Fan case U with
the Body joint plate A to disconnect the Body joint plate A.
5. Pull the Heater cover block up, and remove it.
6. Remove the 2 Duct C fixing screws, and remove it.
7. Separation of the Fan case U from the Heater cover U
• Remove the 6 Clamping bands and the 3 Fan case U
fixing screws.
• Untie 4 lead wire fixing tapes.
• Remove sensor and Discharge air hose.
*Discharge air hose and the Fan case U are fixed by
Clamping band.
• Remove the 4 Fixing screws from the Terminal plate.
• Remove the Fan case U and the Heater cover U.