8
Washing
Preparation:
● Check if the washing machine is properly installed. (P. 14)
● Turn on the water faucet.
● When using Temp Setting, turn on both hot and cold water faucets.
1
After loading laundry
Turn the power on.
2
Select a program.
(P. 6)
e.g.) Normal
program
● Stain Master programs (P. 9)
■
Temp Setting
■
Timer reservation
3
Start.
The pulsator moves without
water and measures the amount
of laundry (approx. 5
seconds).
Water level indication
(approx. 5
seconds)
Remaining time indication
● To check the water level
→Press “Water Level”.
4
According to the water level indication
Put in detergent.
● Approx. 20
seconds after the water level is
displayed, water supply begins.
5
Close the lid.
Operation ends with beeps.
operation. (P. 4)
● 2 minutes after start, all indications
except “Reserve” turn off.
●
press “Reserve”.
● To cancel or change, press “On/Off”.
● The hours that can be set differ
depending on the program.
■
After pressing “Start”
● You can change the water level until the end of
the wash process.
● You can change each of the “Wash”, “Rinse”
and “Spin” operation contents until the end of
the wash process. Press “Pause” beforehand.
● You cannot change the program.
● When using the Soak program, the remaining
time will be displayed (when 90 minutes or less).
23
Timer reservation
Temp Setting
1
Press to select Hot/Warm for washing.
(P. 4)
● To set to Warm, press “Temp Setting”
once. Press again to switch to Hot.
To Next Page
Loading...
