Panasonic NA-F80VG8

6
Detergent
Putting in detergent
Do not put detergent directly into the tub.
Detergent may remain undissolved.
● The level of foaming depends on conditions
such as load size, degree of soiling, detergent
type, and water hardness.
Putting in bleach
● Do not use chlorine bleach for coloured
clothes to prevent loss of colour.
● After using chlorine bleach, wash the tub with
the
9
VỆ SINH LỒNG GIẶT (Tub Hygiene)
program without bleach. (P. 11)
● Do not use bleach for the
3
GIẶT NHẸ
(Delicate) program.
Putting in softener
● Softener is automatically released during the
nal rinse process.
● To add softener during operation, press
“Pause” rst.
● Up to about 70 ml can be added. To add more
softener, use the
4
GIẶT NGÂM NƯỚC XẢ
(Fragrance) program.
● Close the cover securely after the softener is put in.
● When using
concentrated softener,
dilute it with water
before putting it in.
NOTE
● Softener cannot be used with the
7
TIẾT
KIỆM NƯỚC (Water Save) program.
● Do not use separated or solidied softener.
● If “Pause” is pressed during spin cycle,
the softener will be added too early and its
effectiveness will decrease.
● The softener will not be added automatically if
not put in by the time wash process is complete.
Concentrated
softener
Water Water
Put in detergent, bleach and
softener according to the water
level displayed.
● Follow the instructions on each package.
■
Bleach / Liquid Detergent (in Preset mode)
■
Softener
■
Detergent
● Attach the bleach inlet cover if it comes off.
NOTE
● Turn the tub by hand if it is difcult to put
in the softener or bleach inlet. (P. 10)
● When the timer is preset in Preset mode,
put liquid detergent in the bleach inlet.