Panasonic NA-FS85G3 - Motor Replacement; Drain Valve (Gear Motor) Replacement; Pump Replacement

‐17‐
7. Disassembly Instructions
7.7 The MOTOR replacement
7.8 The DRAIN VALVE (Gear Motor) replacement
7.9 The PUMP replacement
1. Laydownthewashingmachineonitfrontside.
2. RemoveleadwireconnectorsandrotationsensorconnectorfromtheMOTOR.
3. Loosenfourbolts(M13)mountingthemotor,andremoveV‐belt.
4. RemovefourboltmountingtheMOTOR,andremovethemotor.
Note:Afterreplacethemotor,adjusttensionoftheV‐beltproperly.
Andthen,setmicro‐processortoinitialmodeofV‐belttensionbyoperating
Test‐Nowater/Checkprocedure‐E.
1. Laydownthewashingmachineonitfrontside.
2. RemoveconnectorfromtheDRAINVALVE.
3. Removethreescrewsmountingthe DRAIN
VALVE.
4. RemovesliderportionoftheDRAINVALVE from
theCOCKROD
A.
5. RemoveDRAINVALVE.
1. Laydownthewashingmachineonitfront
2. RemoveconnectorfromthePUMP.
3. Remove4screwsmountingfromthePUMP.
4. RemovePUMP.
Connector of motor
MOTOR
V-Belt
Connector of rotation sensor
Cock rod A
Drain valve
(Gear Motor)