- 6 -
4. OPEATIONS PANEL
4.1 Control Panel and Function
NA-FS80X1 / FS90X1
Operation Panel
WATER LEVEL
Water level is automatically set according to the
load size (linear water level control).
• The water level indicator which is closest to the
water level determined lights up.
• The water level can be changed manually to the
desired level. (Some water levels may not be
selected for certain courses.)
• To set the water level of 22L, manually select
the water level.
• The cup indication (example:
) indicates
the standard amount of detergent to be used
according to the water level
WASH - RINSE - SPIN
•
Use this button to change the combination, time
and number of washing, rinsing and spinning
cycles.
• To change the operation cycle during the
“WASH” cycle, press the [Start/Pause] button
and then make a change.
Blink
(in progress)
(Example) W
ashing cycle
• To turn on the
power
The power turns off
if the machine is
left unstarted for 10
minutes.
•
To turn off the
power
•
To wash heavily soiled laundry
• To select the course
•
To wash delicate garments
• To start operation
•
To put the operation on pause
NOTE
• The “Normal” course is indicated when the
power is turned on.
• If the indication in the illustration is shown on
the display after the power is turned off, the
power cannot be turned on again immediately.
• To perform
the air dry
RESERVE
• You may select in how many hours (up to 24
hours later) the washing completes in 1-hour
increments.
•
The Reserve function may not be used for the
“Premium Hand Wash”, “Tub Hygiene” and
“Air Dry” courses.
(Example)
To complete washing in
8 hours time
Speedy course
1~24 hours later
Normal
,
My Favorite, Int
ensive
, and
B
lanket course
2~24 hours later
Soak course
3~24 hours later
TIME DISPLAY
Displays estimate quantity of detergent (a cup),
quantity of water (L) and remaining time (min.)
after a start operation.
※
Depend on kind of cloth and setting, remaining
time differs from actual.
Displays how many hours to finish oparation
when programmable timer has been set.
Displays time for “ Intensive ”
OFF/ON
The power automatically turns off when total operation is finished.
The power automatically turns off
if [START/HOLD] button is not
pressed within 10 minutes after
turning on the power.
When the power supply switch is changed to off, buzzer sounds "Beep".
To Next Page
Loading...
