Panasonic NA-FS95G3

‐9‐
5. Test Mode
Check H Check G Check M Check E
Check A Check B Check C
(2)
(1)
1. Set the power switch to "off".
2. Press and hold both the "Water lever" and "Wash" buttons with one hand.
3. Press the power switch to "on".
4. Release your fingers from the buttons and power switch which you pressed in steps (2) and (3) .
(Check A can be carried out in this state with your fingers released)
5. Within three seconds press the "Water lever " button to set the desirer check procedure.
(Carry out checks B, C, E, M, G and H)
Numberoftimes
the"Waterlevel"
buttonispressed
Check
Procedure
CheckContents
LampIllumination
Condition
OperationCondition
0A
•
Cycleendbuzzer
•
Timerindicator
•
Autopoweroff
•
Whentheendbuzzersoundsthree times,the
lampswillsimultaneously flashonandoffin
theremaining timedisplay,andthepowerwill
automaticallybe switchedoff
immediately
afteroperationisfinished.
1B
•
Washing
operation
•
Evenifthereisnowaterinthetub,the
washingoperationwill continuefor10
minutes.
•
Pressthe"Rinse"buttononceFV‐1operates,
andpresstwicetooperateFV‐2,press3time
hotwatervalve(FV‐3)operates.
•
IfthePCBfaultoccurred,
anerrorindication
"H05"willdisplay.
2C
•
Spinoperation
•
Lid/SFswitch
•
Thespinningoperationwill continuefor6
minutes.
•
Checkthelid&SFswitchoperation, while
openinglid
1) "74L"lightsup…Lidswitchworking
2) "86L"lightsup…SFswitchworking