– 18 –
(Continued on next page.)
How to Operate
POWER LEVEL SELECTOR PAD
Each time the pad is touched, the Power Level switches as the illustration below.
P10 P9 P8 P7 P6 P5 P4 P3
P2 P1 P0 PU1 PU2 PL1 PL2 P10
again.
HIGH
P10: 1800 W*
LOW
P3: 30%
P2: 25%
MEDIUM
HIGH
P9: 90%
P8: 80%
P7: 70%
P6: 60%
DEFROST
P1: 340 W
OFF
P0: 0%
HEAT FROM
TOP DOWN
PU1: 50%
PU2: 25%
MEDIUM
P5: 50%
P4: 40%
HEAT FROM
BOTTOM UP
PL1: 50%
PL2: 25%
*IEC Test Procedure
Before operating the oven, make sure it is plugged into a properly earthed
electrical outlet.
A. Manual Single Stage Heating
1. Open the door.
The oven lamp will turn on. “0” will appear in the Digital Display Window.
2. Put the food into a suitable container, place it in the centre of the oven and then
close the door securely.
The oven lamp will turn off.
Note: While “0” appears, operation is available. 1 minute after the door is closed,
“0” will disappear.
3. Select the desired Power Level by touching Power Level Selector Pad.
The selected Power Level will be displayed in the Digital Display Window and the
single stage heating indicator “1” will start to blink.
[Example]: Touch Power Level Selector Pad once for P10 power.
Note: Each time Power Level Selector Pad is touched, the Power Level switches
as the above Power Level Selector illustrates.
4. Set the desired heating time by touching the appropriate Number Pads.
Note: The maximum set time for P1 and P0 is 30 minutes, and 15 minutes for all
others.
[Example]: Touch Number Pads “2”, “0” and “0” for 2 minutes.
5. Touch Start Pad.
A. Heating will start.
B. During operation, the indicator appears from the left.
C. The heating time on digital display will count down.
When touching Power Level Selector Pad, the current power level will be
displayed for 3 seconds.
6. When all time expires, the end of cycle beep tone will sound and all heating will
stop. The display will blink “0000” until the door is opened. 1 minute later cooling
fan will stop.
To Next Page
Loading...
