– 21 –
D. Programming Memory Pads for 2 to 5 Stage Heating
1. Follow Steps 1-5 in “C. Programming Memory Pads for Single Stage Heating” on
page 20.
2. Select Power Level for the second stage by touching Power Level Selector Pad.
The selected Power Level will be displayed in the window and the second stage
heating indicator “2” will start to blink.
[Example]: Touch Power Level Selector Pad once for P10 power.
3. Set the desired heating time by touching appropriate Number Pads.
Note: The maximum set time for P1 and P0 is 30 minutes, and
15 minutes for all others.
However, the TOTAL TIME can be set up to 25 minutes for continuous
heating (1 to 5 stage heating) that excludes P1 and P0.
[Example]: Touch Number Pads “2”, “0” and “0” for 2 minutes.
4. Touch Prog Pad again and the “PROG” sign and the second stage heating
indicator “2” will stop blinking. The total time for both stages will be displayed.
This means that you have completed programming the desired Memory Pad for
the second stage heating.
5. 3 seconds after programming is completed, “0” will appear.
6. Program the remaining pads as desired by repeating the Steps above.
Note: Repeat the above procedure to set Heating for the third stage and later
stages.
E. Memory Pad Heating
1. Open the door.
The oven lamp will turn on. “0” will appear in the Digital Display Window.
Note: While “0” will appear, operation is available. 1 minute after the door is
closed, “0” will disappear.
2. Put the food into a suitable container, place it in the centre of the oven and then
close the door securely.
The oven lamp will turn off.
3. Touch the desired Memory Pad.
A. The currently programmed information will be indicated.
[Example]: Touch Memory Pad “5” (Program No. A-5).
The total number of stages is displayed as “ ” in the bottom.
The heating program (at P1 power for 1 minute, at P10 power for
2 minutes) as programmed on pages 20-21 is set.
Note: To use B or C side Program, touch Shift (A/B/C) Pad before touching
Program Number Pad.
4. Touch Start Pad.
A. During operation, the indicator appears in order from the left.
B. The heating time will count down.
When touching Power Level Selector Pad, the current power level will be
displayed for 3 seconds.
C. When touching Start Pad, the current stage number will be displayed for
3 seconds instead of Program No.
(Continued on next page.)
How to Operate
To Next Page
Loading...
