8.4. Fan motor
1. Disconnect 2 lead wires from fan motor terminals.
2. Disconnect 2 lead wires from fuse holder terminals. (some
models)
3. Remove 4 screws holding fan motor and orifice assy and
detach the orifice assy with fan motor from oven assy.
4. Remove fan blade from the fan motor shaft by pulling it
straight out.
5. Separate the fan motor from the orifice assy by freeing 2
catch hooks on the orifice assy.
8.5. Heater
1. Remove lead wires from lead wire holders.
2. Remove belt from pulleys of circulation fan.
3. Remove 2 screws holding heater fan motor bracket.
4. Remove 1 screw holding exhaust guide.
5. Remove 2 screws holding oven temp sensor.
6. Disconnect 2 lead wires from heater terminals.
7. Remove 4 screws holding the both sides of heater unit and
lift it up carefully.
8. Remove 3 screws holding heater supports and detach the
heater.
8.6. Door assemble
1. Open the door and remove 4 screws holding door C.
15
NN-C2000P / NN-C2000
To Next Page
Loading...
