- Eng-66 -
Before Requesting Service (continued)
PROBLEM POSSIBLE CAUSE REMEDY
Oven will not turn on.
The oven is not plugged in
securely.
Remove plug from outlet, wait 10
seconds and re-insert.
Circuit Breaker or fuse is tripped
or blown.
Contact the specified service center.
There is a problem with the
outlet.
Plug another appliance into the outlet
to check if the outlet is working.
Oven will not start
cooking.
The door is not closed
completely.
Close the oven door securely.
Start/Set key was not touched
after programming.
Touch Start/Set key.
Another program has already
been entered into the oven.
Touch Stop/Reset key to cancel the
previous program and program again.
The program has not been
entered correctly.
Program again according to the
Operating Instructions.
Stop/Reset key has been
touched accidentally.
Program oven again.
"HOT" appears in the
display window.
The cavity is overheated. Operate again after it cools down.
The "
" appears in the
display Window.
The Child Lock was activated by
tapping Start/Set key 3 times.
Deactivate Lock by tapping
Stop/Reset key 3 times.
"H97", "H98" or "H00"
appears in the display
window.
This display indicates a problem
with the microwave generation
system.
Contact the authorised service center.
"DEMO MODE PRESS
ANY KEY" or "D" appears
in the display window.
The oven is under demonstration
mode.
Tap Micro Power key once, Start/
Set key 4 times, Stop/Reset key 4
times.
The control panel keys do
not respond when tapped.
The oven may be in stand-by
mode.
Ensure the oven is plugged in. Open
and close the door to activate.
"U14" appears in the
display window only.
The water tank is empty.
Full it with water and tap Stop/Reset
to reset.
If it seems there is a problem with the oven, contact an authorized Service Center.
To Next Page
Loading...
