4.2. Digital programmer circuit
(D.P.C)
NOTE:
Be sure to ground any static electric charge built up on
your body before handling the D.P.C.
1. Disconnect all connectors from D.P.C board DU.
2. Disconnect 1 grounding connector.
3. Remove 1 screw holding escutcheon base and slide the
escutcheon base upward slightly.
4. Remove door opening lever.
5. Disconnect flat cable CN11 from D.P.C. board AU.
6. Release catch hooks on escutcheon base to move over the
D.P.C. board AU.
10
NN-CT585S / NN-CT565M / NN-CT555W
To Next Page
Loading...
