EasyManua.ls Logo

Panasonic NR-BY55BPS - Repair Safety Cautions; Critical Repair Warnings; General Repair Cautions

Panasonic NR-BY55BPS
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NR-BY558/NR-BY55B/NR-BY608
1. SAFETY CAUTIONS FOR REPAIRING
When you repair the refrigerator, please kindly take care for the following cautions.
1.1 WARNING
1.2 CAUTIONS
Before repairing unit, unplug supply cord
●
Before you repair the refrigerator, please unplug the supply cord.
Use authentic parts when repairing
●
When you replace the parts, please use authentic parts to replace defective parts.
Pay attention to using refrigerant
●
If refrigerant touches fi re, the gas becomes poisonous gas.
Pay attention to refrigerant
●
Do not touch liquid refrigerant. Otherwise your hands may be burnt.
Pay attention to edge of parts
●
Otherwise, your fi ngers may be cut.
Pay attention to fi ns of evaporator and condenser
●
Otherwise, your fi ngers may be cut.
Before transportation, adjust the bolt
●
Otherwise, the fl oor may be damaged.
Do not touch the pipe after brazing
●
Otherwise, your hands may be burnt.
Caution during brazing
●
When you use touch for brazing, please ensure ventilation.
Otherwise, you will be poisoned by carbon monoxide.
Pay attention to getting electricity shock
●
When you check the voltage of terminal, please do not touch the electricity part terminal.
●
When you replace the parts, please wait for 3 minutes at least for discharging capacitor.
Watch the hot parts
●
During operation and after operation, compressor and pipes are hot.
●
Also, under these condition, heater are hot.
●
Do not burn your fi ngers when you touch it.
Check safety after repairing
●
Check the screws, parts, lead wires to take in place.
●
Check the repairing portion whether circumferential parts are damaged or not.
●
Check insulation resistance between supply plug and earth.
●
When install refrigerator, check condition of supply cord and plug.
●
Wipe off the dust on plug.
●
Cutting and seal the electric device carefully.
- 3 -